Gerber HS750 Plus, Руководство пользователя

Страница: 30 / 94

24 HS750
plus
SETTINGS
The HS750
plus
Tool Force Settings Reference Card at the back of
this manual lists tool force settings. Be sure to refer to this list of
settings when changing materials or applications. Below are some
initial suggestions:
! For drawing, start with a tool force setting between .5 and
1. If your pen does not make a clear dark line, you may
wish to increase the tool force setting.
! For pouncing, start with a setting between 5 and 6.
! When cutting regular vinyl in tangential knife mode, try a
tool force setting of .5 and 1.
! When cutting regular vinyl in swivel knife mode, set the
tool force setting at 1. The swivel knife will not pivot at
corners and will begin to cut through the material if the
pressure is set too high.
! Heavier material, such as reflective vinyl, requires
increased tool force settings.
! Worn blades require a higher tool force setting.
! Before cutting, refer to the HS750
plus
Tool Force Settings
Reference Card at the back of this manual for suggested
tool force settings for different tools and materials. Set the
tool force accordingly. If you find that different tool force
settings produce more satisfactory results with your
particular system, tools, and materials, be sure to mark the
preferred settings on your card for future use.