Gerber HS750 Plus, Руководство пользователя

Страница: 15 / 94

Installation 9
Assembling the Plotter
Refer to the illustration on the preceding page to help you
assemble the plotter. The diagram is intended to assist you in
assembly. It is not intended to be an exact depiction of the
HS750
plus
.
1. Use four #6 pan head screws to secure the vanity panel to the
left stand leg.
2. Place the control module (which includes the right stand leg)
on the floor with the four screw holes facing up. Use four #6
pan head screws to secure the vanity panel and left stand leg
to the control module.
3. To put on feet or casters, thread one jam nut onto the shaft of
each adjustable foot. Thread the feet into the holes near the
ends of the stand base.
OR
Thread one jam nut onto the shaft of each caster. Thread the
casters into the holes near the ends of the stand base.
4. Install an end cap in the each of the open ends of the stand
base (four places).
5. Align the two holes at each side of the stand base with the
holes on the top and bottom stand legs. Press the stand base
firmly against the stand legs.
6. Insert a #8 locking pan head screw, with a washer, into each
of the two holes of the bottom stand base (the control
module). Start the two screws but do not tighten them at this
time.
7. Insert a #8 locking pan head screw, with a washer, into each
of the two holes of the top stand base. Start the two screws
but do not tighten them at this time.
8. Verify that the alignment between the stand base and the
stand legs is correct, then tighten the screws.
9. Place the stand upright.