Gerber HS750 Plus, Руководство пользователя

Страница: 50 / 94

44 HS750
plus
Controlled Stop
Use
RUN CONT
(or
RUN SINGLE
) to stop plotting and check the
current job.
To stop a continuous mode plot
1. Press the active Run key. The HS750
plus
stops the plot at the
next logical break in the program.
Note: The slew keys may be pressed to maneuver the
carriage or material. However, when the Run key is pressed
again to exit the pause mode, the plotter will return the
carriage and material to the point where the job was paused.
2. Press either Run key to resume plotting at the exact same
point.
Continuous Plot Exercise
1. Turn on the HS750
plus
. Load plotting paper, install the pen
holder, and set the tool force to .5.
2. Using the slew keys, position the carriage spindle
approximately 1” from the front edge of the plotting paper.
Also, be sure that there are several inches of paper extending
past the carriage spindle and to the left of the plotter.
3. Prepare two plot files. In the Plot Program, choose a left Start
Position and a right End Position for both plots before sending
them to the plotter.
Note: If both plot files have a left Start and left End Position,
they may plot on top of each other.
Note: Entering an X,Y pre-position in the Plot Program is
another way to be sure that plots done in the
RUN CONT
mode
will not plot on top of each other. (See
GRAPHIX ADVANTAGE
Reference.)
4. Press the
RUN CONT
key. Both jobs will plot without going off-
line between them.