Gerber GSx Plus, Руководство пользователя, Страница: 59 / 60

GSx
plus
plotter user reference card
Key/Function Description
RUN SINGLE key
Plot Press RUN SINGLE to plot single jobs. The GSx
plus
returns to the
off-line status (as at power-up) after each job and waits for the
operator to press RUN SINGLE key again to plot the next job.
Controlled Stop Press either RUN key to stop plotting at the next logical break in
the program and check current job. Do not use slew keys or the
orientation for the current job will be lost .
RUN CONT
key
Plot Press RUN CONT to plot two or more jobs continuously. The
GSx
plus
plots one job after the other without pausing between
them and remains on-line until either RUN key is pressed.
Controlled Stop Press either RUN key to stop plotting at the next logical break in
the program and check current job. Do not use slew keys or the
orientation for current job will be lost.
The arrow and SLOW keys do not function while a job is
plotting, during an error condition, or while a RUN light is on,
even if the plotter is idle. Slew Keys
(Arrow Keys)
Press arrow keys to position carriage and material between jobs:
•
Up and down arrow keys move the carriage spindle between
the rear and the front of the plotter.
•
Left and right arrow keys rotate the drum and feed material
through the plotter or back toward the roll holder.
Slow Key Hold the SLOW key while simultaneously pressing any Arrow
key. This slows carriage movement for exact positioning.
Reset Key
Emergency Stop Press the RESET key to stop GSx
plus
operation, clear the current
job from the buffer, and return the plotter to off-line status.
Clear Press the RESET key to stop the error signal after a power-up or
plotting failure. (See Error Conditions Section).
Access Hold the RESET key at power-up to access additional
diagnostics. (See Special Diagnostics Section)