Gerber GSx Plus, Руководство пользователя, Страница: 11 / 60

10
Power Cords
1
Insert the female connector of the GSx
plus
plotter power cord into the
socket on the rear panel of the plotter.
2
Connect the power cords for both the OMEGA system and the GSx
plus
to a multiple outlet strip. The strip should be plugged into a standard,
grounded electrical outlet (115V +/- 10% AC, 60 Hz or 230V AC, 50
Hz).
3
Turn power on at the system and the plotter.
CAUTION: When the power is on, never try to manually move the
carriage, move the drum, rotate the tool, or force the tool up or down.
Attempting to manually move the GSx
plus
in any axis of movement
while the power is on may damage the plotter.
Power-Up Sequence
When the GSx
plus
is turned on, the following sequence occurs:
1
A short beep sounds, the Power light comes on, and the RUN CONT
and RUN SINGLE lights blink.
2
As the GSx
plus
performs self-check tests, the lights over the RUN keys
flash, and one additional beep sounds.
3
When the self-check is complete, the lights blink and the plotter beeps.
4
The plotter beeps and goes off-line. Only the power light remains on.
This is the initial setting at power-up.
Note: Rapid, continuous beeping and flashing lights may signal a self-check
error. See the "Error Conditions" section for more information.