General 90-040, Руководство по установке и эксплуатации, Страница: 19 / 30

19
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
AJUSTING THE UPPER AND LOWER THRUST BEARING
1. For the upper thrust bearing, loosen thumbscrew A . 2. Then manually adjust the thrust bearing shaft B in
or out until the bearing is 1/64” behind the blade.
Retighten the thumbscrew
A.
1/64"
RIGHT SIDE VIEW
A
B
3.
For the lower thrust bearing (under the table), loos-
en thumbscrew C .
4.
Then manually adjust the thrust bearing shaft
D
in
or out until the bearing is 1/64” behind the blade.
Retighten the thumbscrew C.
1/64"
C
D
1.
Open the lower door, and remove the dust tray.
2.
Loosen the belt by turning the knob counterclock-
wise E .
Thick Material = Slower Speed
Harder or Denser Material = Slower Speed
Blades with Fine Tooth Pitch = Slower Speed Thin Material = Faster Speed
Soft Material = Faster Speed
Blades with Few Teeth per inch = Faster Speed
SELECTING AND CHANGING THE BLADE SPEED
This bandsaw is equipped with 2 speed settings: High - 3150 Feet Per Minute (fpm) and Low- 1444 fpm, allowing you
to achieve better results by selecting the appropriate speed based on the type of cut.
Some general guidelines to consider for selecting blade speed:
E