General 90-040, Руководство по установке и эксплуатации, Страница: 18 / 30

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
18
AJUSTING THE UPPER AND LOWER BLADE GUIDES
3. To access the lower guide assembly, unlock and tilt
the table as shown.
4.
Pivot the lower guard
G
under the table to the left to
access the lower blade guides H .
0,02"
0,02"
5 . Loosen the two set screws I using a 3 mm Allen key,
and then adjust the lower guides so that the space
between each guide and the blade is 0.02”. Retight-
en the two set screws
I
.
Note: Use a feeler gauge.
6 . Loosen bolt J and adjust the bracket along the slot-
ted hole so that the guides are at least 1/32” behind
the teeth of the blade to avoid damage during cut-
ting
K
. Retighten the bolt
J
.
G
H
I I
1. Loosen the two knurled nuts A . Adjust the guides us-
ing the knobs B so that the space between each
guide and the blade is 0.02“.
Note: Use a feeler
gauge.
2. Loosen the thumbscrew E and adjust the bracket F
so that the blade guides are at least 1/32” behind
the teeth of the blade to avoid damage during cut-
ting. Retighten the thumbscrew E .
0,02"
0,02"
1/32"
RIGHT SIDE VIEW
A
A
B B
E
F
1/32"
K
J