General 90-040, Руководство по установке и эксплуатации, Страница: 11 / 30

11
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
ATTACHING THE MACHINE TO STAND
2.
Secure the machine to the stand using carriage
bolts, flat washers, nuts, and a 13 mm wrench, and
tighten all the stand mounting nuts
A
.
1. Place the machine on the stand with the help of
two assistants.
A
3.
Loosen the table by turning the lock lever
A
coun-
terclockwise.
4.
Tilt the table by turning the knob
B
.
A
INSTALLING THE TABLE AND THE 90
°
STOP
1.
Install the table on its base by guiding the blade
through the table slot as shown.
2.
Using a 5 mm Allen key, secure the table to its base
by tightening the four supplied cap screws and four
flat washers,
THE BANDSAW IS HEAVY. DO NOT OVER-EXERT. THE HELP OF ASSISTANTS WILL BE NEEDED FOR THE FOLLOWING STEP.
DO NOT GRIP THE BANDSAW BY THE LOWER WHEEL COVER DOOR WHEN LIFTING. KEEP HANDS AWAY FROM BLADE
AT ALL TIMES.
B