General 90-040, Руководство по установке и эксплуатации, Страница: 13 / 30

13
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
5.
Thread the lock knob of the fence handle.
6.
Slide the fence handle into the fence slot as shown.
INSTALLING THE RIP FENCE (CONTINUED)
8. Insert the small carriage bolt into the guide hook,
and then slide a flat washer onto it
B
. Screw on the
knurled nut
C
, and slide the bolt head into the slot
under the guide until the stop is against the table
edge. Tighten the knurled nut to hold the guide in
place
D
.
7.
Pull the handle back towards you and place the
fence on the rail.
Note: the screw A serves as a
stop for the fence.
B
C
D
INSTALLATING THE PUSH STICK HOLDER
1.
Thread the cap screw
A
in the mounting hole on
the left side of the machine, and tighten the jam nut
to secure it in place.
2.
Hang the push stick to keep it handy.
A
A