General 90-040, Руководство по установке и эксплуатации, Страница: 10 / 30

10
3.
Attach a third stand leg using the carriage bolts,
flat washers and nuts.
Note: Tighten the nuts by
hand only.
4.
Repeat with the last leg.
5. Secure the four cross braces tightening the bolts,
flat washers and the nuts with a 13 mm wrench.
6. Place the assembled stand upright on a flat surface.
ASSEMBLY INSTRUCTIONS
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
ASSEMBLING THE STAND
1. Attach two stand legs and a small cross brace us-
ing the carriage bolts, flat washers and nuts.
Note:
Tighten the nuts by hand only.
2.
Repeat with the two longer cross braces as shown.
Note: Tighten the nuts by hand only.