General 90-040, Руководство по установке и эксплуатации, Страница: 12 / 30

BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
5. Screw the table stop bolt with jam nut in the mount-
ing hole
C
under the table, and then set the table
in the horizontal position by hand.
6. Place a combination square on the table against
the blade
D
, and adjust the table until threre is no
space between the square and the blade. Tighten
the lock lever A. Loosen the table bolt until its head
touches the machine E , and then tighten the jam
nut F .
C
D
F
INSTALLING THE TABLE AND THE 90 ° STOP (CONTINUED)
INSTALLING THE RIP FENCE
3.
Fit the rail onto the lock knobs as shown.
4.
Secure the rail in place by tightening the lock
knobs.
1. Slide a flat washer onto each of the four lock knobs. 2. Loosely screw the four lock knobs in the mounting
holes in the underside of the table as shown.
E
12