Generac Power Systems PWRcell 3, Руководство по установке

Страница: 21 / 36

Installing Generac PWRcell Battery
Installation Manual for Generac PWRcell Battery 17
Installing Rear Modules
1.
Verify bottom intake filter is in place. See Compo-
nent Locations
2.
See Figure 4-11 . Angle top of battery module (G)
under and behind bracket lip (H).
NOTE: Battery module ports (I) must face the right side
of the Generac PWRcell Battery body with the COM ports
above the power port.
3.
Slide bottom of module to back of Generac
PWRcell Battery body (J).
4.
Push bottom of module against grounding clips (K).
NOTE: Grounding clips are designed to contact and bite
into the battery module case to provide an equipment
grounding connection.
G
H
K
J
I
009929
Figure 4-11. Installing Rear Battery Modules
Installing Grounding Tabs
1.
See Figure 4-12 . Install two L-shaped grounding
tabs (L) at the bottom of the module on both sides.
2.
Fasten each grounding tab with M4x8 machine
screw (M).
L
M
009930
Figure 4-12. Installing Bottom Grounding Tabs
3.
See Figure 4-13 . Install grounding tabs (L) at the
top of the module on both sides.
4.
Fasten each grounding tab with M4x8 machine
screw (M).
M
L
Figure 4-13. Installing Top Grounding Tabs
Installing Front Modules
See Figure 4-14 . Install front battery modules (N) using
the same procedure as used on the rear modules. See
Installing Rear Modules
N
009932
Figure 4-14. Installing Front Battery Modules