Generac Mobile MGG450, Руководство пользователя

Страница: 29 / 60

Owner’s Manual for MGG450 25
Maintenance
Check Engine Oil Level
An authorized operator should check the engine oil level
daily. The oil level should be maintained between the Full
and Add marks on the engine dipstick. Recommended
fluids are listed in
Engine Oil Recommendations . To
check the engine oil using the dipstick:
NOTE: If engine was running, wait at least ten minutes
before proceeding.
1.
Remove dipstick and wipe it dry with a clean, lint
free cloth.
2.
Slowly insert the clean dipstick into the tube. Verify
dipstick is fully seated in the dipstick tube.
3.
After ten seconds, remove the dipstick and look at
the oil level on both sides. The lower of the two
readings will be the correct oil level measurement.
4.
Add oil (if necessary) to adjust the level. After
adding or changing the oil, the engine should run
for one minute before checking the oil level. Wait
ten minutes to allow the engine to cool and oil to
fully drain into the oil pan.
Typical causes of inaccurate oil level readings:
• Reading the high level of the dipstick.
• Reading the dipstick before the oil fully drains into
the oil pan.
• Inserting and removing the dipstick too quickly.
• The dipstick is not fully seated in the dipstick tube.
Changing the Oil
(000139)
WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
Potential of cancer. Prolonged or repeated contact
with used motor oil has been shown to cause cancer
in laboratory animals. Thoroughly wash exposed
areas with soap and water.
(000127a)
WARNING
(000135)
CAUTION
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
See the 1500 Hour Service Interval Manual (0L5448) for
instructions on changing the engine oil.
Coolant Recommendation
(000149)
DANGER
Risk of poisoning. Do not use mouth to siphon
coolant. Doing so will result in death or serious
injury.
(000154)
WARNING
Risk of burns. Do not open coolant system
until engine has completely cooled. Doing so
could result in serious injury.
(000165a)
CAUTION
Risk of overheating. Do not use any chromate base
rust inhibitor with propylene glycol base antifreeze,
boosters, or additives. Doing so will cause overheating
and possible equipment damage.
Recommended coolant is ZEREX™ Nitrate Free
Extended Life Antifreeze/Coolant. See table below for
mixtures:
* Maximum freeze protection is at 70%.
IMPORTANT NOTE: Higher concentrations of
antifreeze will reduce engine ability to cool. Do not
use high concentrations (greater than 50%) of
antifreeze in warmer climates.
Freezing Point °F (°C)
-12
(-24)
-34
(-36)
-54
(-48)
-90
(-67)
Water (% Volume) 60 50 40 30
Anitfreeze (% Volume) 40 50 60 70*