7.0 - PROGRAMMING THE ALARM SYSTEM
The alarm system has been factory configured but settings can be modified at
any time.
With the alarm disarmed, open the driver door and leave it open.
Turn ignition key "ON".
The status LED will turn ON for 0,5 seconds; while the LED is ON,,
simultaneously press both buttons on the remote control.
The turn indicators and the LED will flash twice to confirm the alarm is in
configuration mode.
To enable and/or disable the functions, proceed as indicated in the table
below. Keep in mind that each time a button is pressed, the system will go to
the next function.
During programming, proceed as follows:
- To enable a function, press textured button ’1’=> LED will flash once
- To disable a function, press smooth button ‘2’ => LED will flash twice.
To modify settings proceed as follows:
Continuous (siren) or
intermittent (horn)
Double pulse unlock
CDL 0.5 or 6 sec.
25” comfort closure
Current absorption sensor
Anti-distraction rearming and
auto-lock
Panic/boot release
Continuous
Disabled
Disabled
0.5”
Disabled
Disabled
Panic function
Continuous
(siren)
Disable
Disable
Disable
Disable
0.5”
Boot
FUNCTION
DEFAULT setting
BUTTON 1
NB:
e
h
t
ti
x
e
“
fI
procedure; the remaining
The end of the programming procedure is always confirmed by 2 flashes of
the turn indicators and the LED.
Turn ignition key “OFF” and close door.
ignition key if turned OFF” during configuration, the system will
functions will remain unchanged.
PAGE 10
BUTTON 2
Intermittent
(horn)
6”
Enable
Enable
Enable
Enable
Panic
Self-arming of engine immobilizer is factory enabled and
cannot be modified in the version for the UK market.
