4.7 - NEUTRAL TIME BETWEEN ALARM CYCLES
4.8 - ALARM DISARMING
OR
After the alarm is triggered, but before another alarm cycle starts, there is a
5” interval during which there will be no reaction to alarm events. The LED
will be ON steady. Normal flashing will resume at the end of the neutral time.
The alarm system can be disarmed by pressing remote control button 1
by touching the electronic key to its receptacle. Disarming is confirmed by 3
flashes of the turn indicators.
If an alarm event has occurred while the system was armed, it will be
signaled by 5 flashes of the turn indicators.
5.8
PAG
E 7
4.9 - ALARM MEMORY
Five flashes of the turn indicators, when iginition is turned ON, will indicate an
alarm event has ocurred while you were away from your vehicle. The last
cause of alarm can be identified by observing the status LED and counting
the number of flashes.
The flashing sequence will be repeated 5 times. To interrupt, turn ignition key “OFF”.
LED SIGNAL
ALARM CAUSE
ALARM
CYCLES
5
5
5
5
No limitations
5
Volumetric sensor
Door/boot switches
Absorption sensor
External magnetic contact
Bonnet switch/perimeter
sensors
Ignition attempt
LED ON (400ms)
LED OFF (2 seconds)
WIRE TAMPER will not be signaled by the alarm memory
because managed by the external self-powered siren.
