PAG 1
E 3
10.0 - LEARNING NEW CONTROL DEVICES
To carry out the operation successfully, make sure the required electrical
connections (door /bonnet switch and ignition) have been completed.
1)
Do not close the bonnet otherwise all previously programmed
devices will be erased.
2)
3)
4)
5)
6)
7)
8)
9)
Storing memory is for 8 devices (remote controls, electronic keys or magnetic
contacts (protection devices). If an extra device is added, the LED will start
flashing quickly to indicate the memory is full. To activate the learning
procedure, proceed as follows:
With the alarm system disarmed, open the driver door and bonnet and leave
them open.
Turn ignition key ON.
Press a button on an already learned remote or insert an already learned
electronic key in its receptacle.
Two slow flashes of the turn indicators will confirm the system has entered in
learn mode.
According to the device to be learned: press remote control button 1 OR
introduce the electronic key in its receptacle OR make the magnetic contact
transmit (bring contact and magnet close together and then move apart).
The status LED will flash once to confirm learning of a new device.
Repeat the procedure from step 5 to program any other device.
Turn ignition key OFF.
A long flash of the turn indicators will confirm the end of the procedure.
11.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.
