PAG 1
E 2
8.5 - PASSIVE ARMING
8.8 - CDL DOUBLE PULSE UNLOCK
9.0 - ULTRASONIC VOLUMETRIC SENSOR ADJUSTMENT
Engine block passive arming, if enabled, automatically activates the double
ENGINE LOCK 60 sec. after the engine has been switched OFF or 60 sec.
after the alarm has been disabled (if engine is not switched back on).
The status LED will flash quickly to confirm activation.
This function, if enabled, provides a double pulse unlock (approx. 0,5 seconds
each) upon disarming the system.
With the two-stage unlock, the first pulse unlocks the driver door and the
second pulse the remaining doors.
This function is only active if the lock/unlock time is set at 0,5”. Setting 6” will
automatically disable double pulse unlock.
The volumetric sensor provides interior protection. To adjust the sensitivity
level according to the area to the area that needs to be covered proceed as
follows:
- Arm the system excluding the sensors (see relative paragraph).
- Adjust the trimmer at a medium setting.
- After the arming delay, introduce an object in the cabin through the window
and move it around; the status LED will turn ON to signal a presence.
- If sensitivity level is too high or low, readjust the trimmer and repeat the above
procedure.
If a door is opened during the passive arming countdown, the countdown will
stop and start over again when the door is closed. The LED will be ON steady.
The comfort control feature automatically closes all windows when the alarm is armed.
If this function is enabled, the power window motor will receive a 25” command
to roll-up all windows when the alarm is armed.
8.6 - LOCK TIME
8.7 - COMFORT CONTROL
The lock time is factory preset at 0,5 seconds but it can be adjusted to 6
seconds during the programming phase.
If the comfort function has been enabled, keep the lock time set to 0,5”.
Setting it at 6” will cause the windows to open when the alarm is disarmed.
