Gema OptiFlex Pro B Spray, Инструкция по эксплуатации и список запасных частей

Страница: 38 / 58

Rev. 00 03/19
38  Operation OptiFlex Pro B Spray
Color change
General information
When a color change takes place, the individual components of the
manual coating equipment must be cleaned carefully. All powder particles
of the former color must be removed during this process!
The following describes an 'extreme' color change (light to dark).
1. End the coating procedure
CAUTION
Large dust formation possible!
Uncontrolled escape of pulsating compressed air and powder can
cause eye or ear damage and respiratory problems.
► Lift the fluidizing/suction unit
2. Lift the fluidizing/suction unit
3. Point the gun into a suction unit or into the booth
4. Activate the cleaning mode either on the rear of the powder gun
(remote control) or on the control unit
5. Select the corresponding cleaning program – See chapter
"Activating the cleaning function" on page 35.
6. Press the gun trigger
– The automated cleaning procedure is started.
– After completion of the cleaning procedure, the controller
switches back to coating mode.
7. Dismantle and clean the powder gun (see therefore the user manual
of the powder gun)
8. Clean the fluidizing/suction unit with compressed air.
9. Remove the swivel arm and blow off with a compressed air gun
10. Prepare the manual coating equipment with new powder for start-up