Geist Watchdog Wi, Инструкция по эксплуатации

Страница: 96 / 105

Geist Watchdog Wi Instruction Manual 96
© 2017
GM1212 Geist Watchdog Wi Instruction Manual
Figure 4-41 Admin Menu, Firmware Page - Firmware File Upload
Navigate to the first file using the browse button, and then click on upload for the unit to
take the file. This process takes about 60 seconds to complete.
Load the Firmware Using TFTP
You can also use TFTP to update the firmware file. Before updating the firmware through
TFTP, the firmware flash application must be exited and then erased. To do this, navigate
to the Watchdog Wi’s configuration menu. Once here, click on the “Exit to Bootloader”
button. Once exited, you will get a bootloader web page at the IP address of the unit.
Next, click on the “Erase Flash” button. The Flash application will be erased.
NOTE
To erase the flash, a special username and password are
required. The username is fds (all lowercase), and the password
is Geist2tech (all lowercase).
Uploading firmware via TFTP requires a TFTP Client. It may be possible to download a
free license TFTP Client from the internet. Consult your IT department to determine a
compatible client program.
Verify that your PC and the Watchdog Wi are on the same subnet (LAN).
Open your TFTP client. Configure the client as follows.
Host = Watchdog Wi’s IP Address
Port = 69
Block Size = 64, 128, 256, 512, or 1024