Geist Watchdog Wi, Инструкция по эксплуатации

Страница: 61 / 105

Chapter 4 - Final Checkout 61
© 2017
GM1212 Geist Watchdog Wi Instruction Manual
System Location Enter the address of the Watchdog Wi ’s physical location.
V1/V2C Community Names When communicating via SNMP V1/V2, identify devices that
receive Traps and/or Syslog messages from the Watchdog Wi and communicate with the
Watchdog Wi over the network.
Get / Read Enter the appropriate community name.
Set / Write Enter the appropriate community name.
Trap Enter the appropriate community name.
Traps
Trap Type Select the SNMP version that best suits your needs:
V1 - Trap, V2C - Trap, V2C - Inform, V3 - Trap, or V3 - Inform.
IP Version Designate whether traps will be sent via IPv4 or IPv6.
Max. Inform Retries If the communication of a trap fails, this is the maximum
number of times the Watchdog Wi will re-send the trap.
Inform Interval This is the amount of time that lapses between re-sends.
Trap Destinations
Trap Enabled Check the box to allow a trap to be sent to the device defined
in this row.
IP Address This is the IP address of the device that the trap will be sent
to.
SNMPv3 EngineID If this device uses SNMPv3, data will populate in this field.
User Name Enter a unique name for each SNMPv3 user.
Access Mode Choose from the following Watchdog Wi :
No-Auth
Auth-MD5, No-Priv
Auth-MD5, Priv-DES
A user name is needed for No Authentication, and a user
name and password are required for Authentication and
Privacy Authentication access.
Auth. Password (8-24 chars) Enter the authentication password - the password must be
between 8 and 24 characters long.
Priv. Password (8-24 chars) Enter the privacy (encryption) password - the password must
be between 8 and 24 characters long.