Geist Watchdog Wi, Инструкция по эксплуатации

Страница: 101 / 105

Chapter 4 - Final Checkout 101
© 2017
GM1212 Geist Watchdog Wi Instruction Manual
IP Address Reset
This guide explains how to find the current or change the current IP address of the
Watchdog Wi (WD-Wi) when it is unknown.
NOTE
A serial connection is required.
Step 1: Accessing the WD-Wi
Connect the Serial cable and open a terminal connection. Type ‘RESET’ and press
enter twice.
This will enter you into bootloader mode
Figure 4-42 Bootloader mode
Step 2: Reset IP address
Type ‘IP’ then the IP address you are wanting to set to the WD-Wi then press
enter.
Type ‘NM’ then the Subnet you are wanting to set to the WD-Wi then press enter.
Type ‘DG’ then the Gateway you are wanting to set to the WD-Wi then press
enter.
Figure 4-43 IP Address entry
Step 3: Restarting the WD-Wi
Type ‘RUN’ and press enter once.
This will reboot the system. There will be a 120 second reboot time.