gefran TPD32-EV-...-2B, Инструкция по эксплуатации

Страница: 428 / 504

—————— TPD32-EV ——————
428
“Opt2-A/”(Low priority)
“PDC” (High priority) Parameter available via APC300 asynchronous communication
(see the APC300 user manual) and/or the Process Data Channel
(PDC).
When using a field bus interface, parameters whose range is
[min=0; max=1] can be assigned to either Virtual digital inputs
(if W access code exists) and/or Virtual digital outputs (if R
access code exists).
The numbers indicate what has to be sent via interface line in
order to set the single parameters.
Letter in brackets in the “Term.” columnAnalog level to be ap
-
plied to the terminal in order to start the single function.
IA, QA, ID, QD in the “Term.” column The function can be accessed via a freely programmable analog
or digital input or output.
IA = analog input
QA = analog output
ID = digital input
QD = digital output.
The eventually present number is the one by which the terminal
is called.
H, L in the “Term.” column Level of the terminal signals (H=high, L=low) which enables
the single function.
R/W/Z/C Access possibilities via the serial interface, Bus or Opt2 manual
or asynchronous communication :
R = Read,
W = Write,
Z = Write only when drive disabled,
C=Command parameter (the writing of any value causes the
execution of a command).
X · Pyy The value of this parameter can correspond to min/max X times
the value of the yy parameter.
n
ote
! The parameter number here indicated has to be intended as an offset value, that the user has
always to add to the base value 2000H (= decimal 8192), in order to address parameters when
a serial line/bus or the APC300 card are used. It also possible to accede to the DRIVECOM
parameter with the DRIVECOM standard indexes.
*
When the parameter is accessed by Opt2-A/PDC the format is U16.
**
When the parameter is accessed by Opt2-A/PDC the format is I16.
***
When the parameter is accessed by Opt2-A/PDC the lower word of the parameter is
considered.