gefran ADV200 SP Series, Быстрый старт, технические характеристики и установка

Страница: 42 / 106

42
ADV200 SP • Quick start up guide - Specification and installation
6.2.3 Scanning of the parameters
T+ T- EN LOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
T+ T- EN LOC ILim n:0 AL
0 1 . 0 1 PA R : 2 5 0
Output current
+
0 . 3
A
T+ T- EN LOC ILim n:0 AL
0 1 . 0 2 PA R : 2 5 2
Out ut volta e p g
-
1
V
T+ T- EN LOC ILim n:0 AL
0 1 . 2 2 PA R : 1 4 0 0
Digital out ut X mon p
0
. . .
. . .
6.2.4 List of the last parameters modified
Pressing the CUST key, a list containing the last 10 parameters modified is accessed. One parameter at a time
is displayed and the list can be scrolled using the ▲ and ▼ keys.
To exit this list, press the ► key.
6.2.5 “Goto parameter” function
Pressing the CUST key twice, or once if already in the “List of modified parameters”, the “Goto parameter” is
activated.
This function permits access to any parameter entering only the software number of the parameter (PAR).
When the parameter reached by the “Goto” command is displayed, it is possible to navigate all the parameters
forming part of the same group using the ▲ and ▼ keys.
Pressing the ► key returns to the “Goto” function.
To exit the “Goto” function, press the ► key.
6.3 Parameter modification
To enter parameter modification mode, press the E key when the parameter to be modified is displayed.
To save the value of the parameter, following modification, press the
E
key again.
Note !
To save permanently, see paragraph 6.4 .
To exit from modification mode without saving the value, press the
ESC
key.
The operations to be carried out to modify the value depend on the type of the parameter, as described below.
Note !
For further information about the type of parameters displayed, see chapter Parameters List (ADV200 SP FP
manual) .
● Numeric parameters
T+ T- EN LOC ILim n:0 AL
13 DIGITAL OUTPUTS
14 ANALOG INPUTS
15 ANALOG OUTPUTS
16 MOTOR DATA
E
T+ T- EN LOC ILim n:0 AL
1 6 . 0 1 PA R : 2 0 0 0
Rated voltage
+
400
V
Def: +400
T+ T- EN LOC ILim n:0 AL
1 6 . 0 1 PA R : 2 0 0 0
Rated voltage
+
V
Def: +400
0 0 0 0 0 0 4 0 0
When E is pressed to access modification mode, the cursor is activated on the digit corresponding to the unit.
Using the ◄ and ► keys, the cursor can be moved to all the digits, including trailing zeros that are normally not
displayed.
With the ▲ and ▼ keys, the digit under the cursor is increased or decreased.
Press E to confirm the modification or ESC to cancel.