Geely JL481Q, Руководство пользователя

Страница: 160 / 198

Poxtion for grease
Fig. 344 Install release fork Fig. 345 Position for grease
Fig. 346 Install bolt with washer, locking plate Fig. 347 Check the operation of release bearing and clutch release fork.
Fig. 348 Grease application
When making adjustment, minimize the number of adjusted pawls.
(3) Assemble the clutch release bearing and release bearing circlip onto clutch release fork.
a. Put the notch of the clutch release fork against circlip
b. Under conditions specified in a), turn the clutch release fork 180° and assemble them together(Fig. 344).
Smear lithium base grease on the relative slip surfaces of clutch release fork and release bearing, and the relative slip
surfaces between release bearing and release sleeve (Fig. 345)
(4) Install bushing, dust proof cover, torsion spring and clutch release lever.
(5) Install bolt with washer, locking plate (Fig. 346). Tightening Torque: 29.4 – 39.2 Nm
(6) Check the operation of release bearing and release fork, run the clutch release fork about 40~50 times and check the
position A on release bearing circlip. Replace with a new circlip if the release bearing spring is stretched too much or likely
to fall off. (Fig. 347)
(7) Install the transmission unit onto the vehicle.
͔
II
͕
. Clutch Operating Mechanism Assembly
Assembly:
(1) Smear grease as shown in Fig. 348
(2) Install torsion spring, bush, spacer, install pedal assy. onto
bracket and fasten bolts.
(3) Connect both ends of clutch cable, fix the cable bracket with
bolts (Fig. 349), tightening torque: 3.92 –6.86Nm
Turn 180
156