assembly and installation
Preparations before installation
7160-9001-560
01. December 2020
5
assembly and installation
If necessary, contact your nearest authorized technical dealer.
5.1
Special Personnel Qualifications
Installation may only be carried out by specially qualified personnel in accordance
with the safety instructions.
● Participation in corresponding product training is necessary.
See also the section on ”Personnel qualification”.
5.2
Safety Instructions
To prevent damage to property and/or life-threatening injury to personnel always
observe the following:
● The installation must be carried out in accordance with national standards and
regulations.
Example:
Carry out electrical installation work in accordance with the following standards
and requirements:
- EN 60204, Point 14 (Electrical equipment of machines).
- VDE 0100 (Regulations on the erection of power installations)
● Before installation, look for any damage caused by transport. Do not use
damaged components.
● Use only the special tool indicated for assembly.
● In the cases of devices with 24 V direct voltage, the power supplies stipulated
by the manufacturer and approved for the devices must be used, because the
safety of personnel and of the building cannot be ensured otherwise.
● Also read the chapter on Safety.
5.3
Particular hazards
● Electronic components may be damaged by electrostatic processes.
- Only touch the edge of the plug-in contacts and avoid static caused for
example by clothing.
● Before working on electrical installations or equipment (components, housings,
etc.), they must be disconnected from the mains.
Any on/off or emergency stop switches must be fitted with a lock to immobilise
them in the open position and a warning sign should be put up.
● Components which have been incorrectly set down or which have not been
fastened properly may fall off or collapse.
● Parts loosely placed on top of each other can slip and fall off.
● Components with sharp edges which are still exposed and accessible represent
a source of injury.
5.4
Requirements
The product must be installed in a well ventilated frost-free room.
Environmental Specifications
See section: "Technical data"
5.5
Preparations before installation
Necessary documents
For more information on this subject, please refer to the section on
Information on the document
