GE Profile PSB42LGRBV, Техническое обслуживание руководство

Страница: 30 / 72

– 30 –
To Icemaker To Water Tank
Water Valve and Water Tank
The water valve is mounted in the left section of
the machine compartment.
The icemaker water line is routed from the water
valve, through the machine compartment, and
to the icemaker fi ll tube. The water tank line is
routed from the water valve, through the back
of the machine compartment, down the back
of the cabinet, through the bottom of the unit,
and into the fresh food compartment where it is
attached to the water tank. The water tank holds
approximately 35 oz of water.
The door dispenser supply line is routed from the
cold water tank, through the bottom of the unit,
and into the freezer door.
The dispenser valve (blue coil) delivers fi ltered
water through the water tank to the freezer
door dispenser. The coil has a resistance of
approximately 325 Ω.
The icemaker valve (brown coil) delivers fi ltered
water directly to the icemaker. The coil has a
resistance of approximately 180 Ω.
The dispenser coil receives 120 VAC from CN08,
between pin #2 (when
WATER
is selected) and
CN08, pin #3 (neutral).
The icemaker coil receives 120 VAC from
terminal block location CN08, between pin #1
(when the icemaker is calling for fi ll water) and
CN08, pin #3 (neutral).
The incoming water line is routed under the unit,
up the back of the refrigerator cabinet, into the
machine compartment, through the GWF water
fi lter, and into the inlet of the water valve.
From the water valve, 2 low-pressure water lines
independently supply water to the icemaker and
water tank.
ICE MAKER
DISPENSER
WATER VALVE
CN08
PURPLE
GRAY
RED
Note: The water fi lter should NOT be installed if
the home has a water fi ltration system in place
(reverse osmosis fi lter system, etc.) Replace the
fi lter with the bypass plug.
Ice Dispenser
The water, crushed ice, and cubed ice functions
are controlled by the power control board (PCB).
To select a function, press the appropriate pad
on the dispenser. The LED will light to identify the
selection. To dispense the selected item, depress
the dispenser pad located in the recessed area.
With any ice selection, the duct door motor and
cam will open the chute door, and upon release,
delay its closure. A motor and cam replace the
more familiar duct door solenoid.
When
CUBED
is selected on the ice dispenser
control panel, the cube motor behind the ice
bin rotates. The motor cam lifts a linkage arm
allowing the ice to bypass the crusher blades. A
motor and cam replace the ice cube solenoid.
Dispenser Light
The light bulb is a 6-watt 12 VDC bulb
(WR02X10675). Check for 12 VDC at CN03 on
the terminal board, between pin #4 and pin #5,
with the dispenser switch in the closed position.