GE Multilin D400, Инструкция по эксплуатации

Страница: 103 / 192

CHAPTER 7: SETTING UP THE D400 FOR REDUNDANCY
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL GE INFORMATION 103
3. Enter 4. Peer IP Address (IP of Active D400) .
Result: The D400 Redundancy Configuration Menu - Peer IP Configuration menu
appears.
4. Specify the Peer IP address.
5. Enter 8. D400 A/B Designation .
Result: The D400 Redundancy Configuration Menu - Redundancy D400 Designation
(A/B) Configuration menu appears.
6. Enter 2. D400_B .
7. Enter the remainder of the configuration settings identical to the primary D400. See
“Task 4: Hot standby - Configure the primary D400 for redundancy” on page 101.
8. Enter 19. Reboot D400 and wait for a minute.
Result: All of the D400 applications are restarted and run in Hot-Standby mode.
This D400 (D400_B) communicates to the peer D400 (D400_A) and declares itself to be the
Standby D400 since the peer D400 is already in Active mode.
Task 6: Hot standby - Verify configuration
To verify that the configuration is correct:
1.
At the
D400#>>
command prompt of the primary D400, enter d400cfg .
2. Enter 14. Redundancy .
3. Enter 1. Current Configuration .
4. Repeat the steps of this task for the secondary D400.
5. Compare the primary and secondary configurations.
Task 7: Hot standby - Verify redundant D400 operation
To verify that the D400s are operating as redundant devices:
1.
Login to D400 remote-HMI and enter credentials.
2. Click Point Summary button.
3. Click the Application tab.
4. Click Redundancy Manager Details .
5. Repeat the steps of this task for the secondary D400.
6. If the State of peer D400 point is Non Sync, then synchronize the configuration by
entering the
DirectOperate -> PulseOn command on the SyncConfig point.
7. Compare the configurations.
8. Confirm that the State of peer D400 pseudo point is Standby.