GE Monogram ZIRS360NNLH, Руководство по установке

Страница: 27 / 32

27
Installation Instructions
STEP 16 ADJUST DECORATIVE PANELS - FLUSH INSTALLATION ONLY
The panel can be adjusted approximately 1/8” both left
and right, up and down, as well as outward from the
door to provide planar appearance with cabinets.
NOTICE: Misaligned panels from incorrect drilling or incor-
rect cut dimensioning may result in less possible adjust-
ment as well as possible interferences with other attached
panels and/or hardware.
1. The gap between the outside edge of the door panel
and the cabinet opening should be 9/16”. Adjust panel
until specified gap is maintained.
2. Turn the set screw at the hinge side (top and bottom) of
the appliance clockwise to adjust the door panel toward
the edge of the door opening. Check the gap by closing
the door.
3. Check that the door panel is in plane with the face of
the cabinets. The panel can be adjusted outward by
turning the set screw threaded into the tab of the door
bracket at the top and bottom of the door clockwise
until the face of the panel is in the same plane as the
cabinetry.
4. Check the flushness of the panel with the cabinetry.
If the grille is not flush, adjustments can be made by
loosening the screws in the slots on the hinge and mov-
ing the panel in or out. Once all adjustments are made,
retighten screws and close the grille.
9/16” 9/16”
Door panel and hood
panel should be flush with
the fronts of the cabinets.
Turn set screw on
hinge side, top and
bottom, clockwise
to move toward the
door opening.
Turn set screws on tabs at
top and bottom of door to
move panel in or out to be
flush with cabinetry.
Use these screws
to adjust the grille
panel in or out -
both sides.