GE MDS Mercury Series, Справочное руководство

Страница: 79 / 196

05-4446A01, Rev. C Mercury Reference Manual 71
•
RX IP Port
—Receive IP data from this source and pass it
through to the connected serial device. The port number must
be used by the application connecting to local TCP or UDP
socket. [
Any valid IP port; 30010
]
•
TX IP Address
(used instead of
Local IP Address
when using
UDP Point-to-Multipoint)— Configure with a valid Multi-
cast address (224.0.0.0–239.255.255.255). IP packets
received with a matching destination address are processed
by this unit. [
Any legal IP address; 0.0.0.0
]
•
TX IP Port
(used instead of
Local IP Port
when using UDP
Point-to-Multipoint)—This port number must match the
number used by the application connecting to local TCP or
UDP socket. [
1-64,000; 30010
]
•
Talkback Enable
—Talkback is a mode where the radio returns
a serial message received within a time-out period back to the
last address of an incoming UDP message. If the time-out
expires, the unit sends the serial data to the configured
address. [
Enable, Disable; Disabled
]
•
Baud Rate
—Data rate (payload) for the
COM
port, in
bits-per-second. [
1,200–115,200; 19200
]
•
Byte Format
—Formatting of data bytes, representing data bits,
parity and stop bits. [
7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2,
7O2, 8N2, 8E2, 8O2; 8N1
]
•
Buffer Size
—Maximum amount of characters that the Remote
end buffers locally before transmitting data through the serial
port. [
1–255; 255
]
•
Inter-Packet Delay
—Amount of time that signal the end of a
message, measured in tenths of a second. [
default = 1 (that is,
1/10th of a second)
]
•
Commit Changes and Exit Wizard
—Save and execute changes
made on this screen (shown only after changes have been
entered).