GE MDS Mercury Series, Справочное руководство

Страница: 52 / 196

44 Mercury Reference Manual 05-4446A01, Rev. C
•
AP Location Push Config
—Presents a submenu for configuring an
AP to automatically force connected remotes to receive the AP
Locations file from the AP. See
“AP Location Push Config
Menu”
on Page 55 for details.
•
SNTP Server
—Address of SNTP server (RFC 2030) from which
the transceiver will automatically get the time-of-day. You can
also manually set the date and time. A Mercury unit tries to get
the time and date from the SNTP server only if an IP address is
configured. It will continue to retry every minute until it suc-
ceeds.
The transceivers use UTC (Universal Time Coordinated) with a
configurable time offset. [
0
]
NOTE:
The Mercury gets time of day data from the GPS receiver if the
receiver gets a satellite fix.
Network Interface Configuration Submenu
Invisible place holder
Figure 3-12. Network Interface Configuration Submenu
•
VLAN Status
—This selection is used to enable or disable virtual
LAN operation. For details, refer to
VLAN Configuration Menu
on Page 45 . [
enable, disabled; disabled
]
•
IP Configuration
—This selection presents a submenu for config-
uring the local IP address of the transceiver. Detailed explana-
tions are provided in the section titled
IP Configuration Menu
on Page 50 .
•
DHCP Server Config
—Menu for configuration of DHCP services
by the Access Point. DHCP provides “on-the-fly” IP address
assignments to other LAN devices, including Mercury Series
units. For details, refer to
DHCP Server Configuration (Data
and Mgmt)
on Page 48 .