Chapter 3: Programming
Concord 4 Installation Manual
71
Accessory modules menu
The Accessory modules menu gives you access to the following menus:
Bus devices:
Use these settings to read bus device unit numbers, assign bus devices
to a partition, and configure other features associated with a specific bus device.
(Most bus device settings do not have shortcut numbers).
SnapCards:
Use these settings to set the configuration number for each SnapCard
output, assign SnapCard outputs to a partition, and name the SnapCard outputs.
Accessory modules - bus device settings
Unit-ID
Shortcut: 10000 to
10015
Default: **** or None
This menu lets you identify all connected bus devices, view each unit
number, view the device ID number, and configure other settings based on
a specific device. This menu also lets you delete learned bus devices.
To help identify bus devices, the 8-digit device ID number is also located on
a label on each SuperBus 2000 device.
To identify bus device unit and ID:
1. With the display showing
BUS DEVICES
, press #. The display shows the
bus unit number and the 8-digit device ID number. For example:
UNIT -
ID 0—02110185
. Where 0 is the unit number and 02110185 is the device
ID number.
2. Press A
or B
to identify all other bus unit numbers (0 to 15) and device ID
numbers.
To delete learned unit numbers:
1. With the display showing
BUS DEVICES
, press #. The display shows the
bus device set to unit number 0.
2. Press A
or B
until the bus device unit number you want to delete is
displayed.
3. Press D. The display changes the unit number to None.
Device ID
Default: None
This menu lets you change the bus device ID number when replacing a
defective bus device.
To change a device ID:
1. With the display showing the desired bus device, press #, #. The display
shows
DEVICE ID
(current ID).
2. Enter the ID of the new bus device. The display flashes the entered
selection. Press #
and the display shows the new setting.
3. Exit programming mode.
4. Remove AC and battery power from the panel.
5. Replace the defective bus device with a new one.
6. Apply AC and battery power to the panel.
Содержание Concord 4
Страница 1: ...GE Security P N 466 2182 REV G ISS 12JUL10 Concord 4 Installation Manual ...
Страница 6: ...iv Concord 4 Installation Manual ...
Страница 96: ......