17
Figure 20. Network connector
4. Connect an external device.
Note:
This step is optional. If you are not connecting an external device, go to the next step.
To connect the device, do the following:
a. Remove 0.12 to 0.28 in. (3 to 7 mm) of the outer jacket of the cable from the external device
(AWG #16 to 28 single core, twisted) and twist the core of the power cord to prevent a short circuit
(
Figure 21
).
Figure 21. Remove outer jacket
b. Loosen the screws of the external I/O terminals plug and insert the cables from the external device
into the external I/O terminals plug until the exposed core wires are completely hidden
(
Figure 22
).
Figure 22. External I/O terminal plug
c. Tighten the screws to secure the inserted cables. Make sure that the exposed core wires are
completely hidden after tightening the screws.
Note:
Do not connect two more wires directly to a terminal. If it is necessary to connect two or more wires, use a splitter.
d. Insert the external I/O terminals plug into the external I/O terminals on the mounting side of the
camera (
Figure 23
). Make sure the plug is firmly inserted into the terminals.
Network connector
Approx. 0.12 to 0.28 in (3 to 7 mm)
1 2 3
4
