GE Medical Systems Dash 3000, Руководство по обслуживанию

Страница: 140 / 232

CONFIGURATION:
6-18 Dash 3000/4000 Patient Monitor Revision B
2000966-105
Error Code
The error log contains more than just operating system errors. Many
events that have an impact upon the system are also entered into the log.
The 700-series of error codes are really system initiated events. Listed
below are some of the event/error codes you might find useful.
NOTE: The monitor may be referred to as a display or scope in the error
code descriptions.
Severity
Severity is a measure of how the event/error affected the system. There
are three levels of severity.
CONTINUE—the event/error was logged, the task may have or may not
have been finished, but the system was able to go on. Most log entries
will have a severity of CONTINUE.
FATAL—the event/error was such that the task is not able to go on.
Recovery was not possible. This always is followed by a WARM START.
FORCED RESTART—the system was restarted by a known condition
(internet address change, video test, etc).
Definition of Error Codes
Error Code Description
400-4FF Network errors were detected.
703 Diagnostic tests were completed.
70B Internet address was changed. The network address
for the monitor was changed. This should only be done
by qualified service personnel.
70C Video test was completed. This test should only be
performed by qualified service personnel.
70E Time was changed from this monitor. This helps
determine how the system-wide time may have been
altered.
70F Date was changed from this monitor. This helps
determine how the system-wide date was altered.
710 Incompatible software was detected. If the main
processor software finds that the software operating
on the communication software incompatible, it turns
off the communication (network) controller and enters
this data into the error log. When the monitor won’t
“talk” to the network, looking for this entry in the
error log is one part of the troubleshooting process.