GE HEALTHCARE E-PSMP, Техническое руководство

Страница: 209 / 622

Masimo Module, E-MASIMO
6 - 7
2062973-004
3.3 Functional check
Turn the monitor on. Wait until the normal monitoring screen appears.
3.3.1 Test setup
Required tools
− Masimo SpO
2
finger sensor, adult
− Masimo SpO
2
interconnect cable
NOTE: See the CARESCAPE monitor supplemental information manual for compatible
accessories.
Connections
1. Ensure that the module is connected to the monitor.
2. Connect the SpO
2
interconnect cable to the SpO
2
connector in the module.
3. Connect the SpO
2
finger sensor to the SpO2 interconnect cable.
Monitor configuration
1. Configure the SpO
2
waveform field to the monitor screen with adequate priority.
3.3.2 SpO
2
test procedure
1. Connect the SpO
2
finger sensor to your finger. Wait until a pulse is found.
2. Check that the SpO
2
reading in the parameter window is between 90-100 and the
plethysmographic waveform appears on the screen.
NOTE: You can verify the functionality of a pulse oximeter probe and monitor with a functional
SpO
2
tester but you cannot evaluate their accuracy with such a device. However, if a particular
calibration curve is accurate for the combination of a pulse oximeter monitor and probe, a
functional tester can measure the contribution of a monitor to the total error of a
monitor/probe system. The functional tester can then measure how accurately a particular
pulse oximeter monitor is reproducing that calibration curve.
3.
Mark this task as complete on the checkout form.
3.3.3 Test completion
Select Discharge patient or Reset case to discard any changes made to the monitor
configuration during checkout.
4.
Complete on the “Maintenance check form” on page 6-17.