GE HEALTHCARE E-PSMP, Техническое руководство

Страница: 187 / 622

Pressure Modules, E-P, E-PP, E-PT
5 - 21
2062973-004
Message Location Possible causes Possible Solutions
No P5 transducer
No P6 transducer
No P7 transducer MF Pressure transducer and/or
transducer adapter cable
disconnected from the
module. Connect pressure transducer
and/or transducer adapter cable
to the module.
Not zeroed
IPs not zeroed
PW, WF
MF
There is at least one invasive
pressure channel, which is
not zeroed. Zero all invasive pressure
channels
P5 Over range
P6 Over range
P7 Over range
‘>320mmHg’ or ‘>43 kPa’ MF
MF
MF
PW Measured pressure exceeds
320 mmHg / 43 kPa
measurement limit.
Transducer not zeroed
correctly.
The measurement range is
between –40 mmHg and 320
mmHg.
Zero the invasive pressure
channel.
P5 under range
P6 under range
P7 under range
'<-40 mmHg' or '<-5 kPa'
MF
PW
Measured pressure exceed
-40 mmHg /-5 kPa
measurement range.
Transducer is not zeroed
correctly.
The measurement range is
between -40 mmHg and 320
mmHg.
Zero the invasive pressure
channel.
Pressure measurement
removed MF The module is disconnected. Reconnect the module.
Identical IP5 modules
Identical IP6 modules
Identical IP7 modules MF Identical IP modules. The
monitor detects the same IP
channel from two or more
modules.. Remove one of the modules
providing identical IP channel.
Calibrating PW Calibration of an invasive
pressure channel is in
progress. Wait until calibration is completed
successfully.
Calibration failed PW Pressure calibration failure
due to time-out.
Pulsating waveform
detected during calibration.
Gain is beyond the limits (±
20% of the default gain)
Re-calibrate. Start inflating the
pressure within 45 seconds after
the automatic zeroing is
completed.
Check the manometer reading to
ensure that a static 100-300
mmHg pressure is present for
calibration
Replace the transducer and
re-calibrate.