GBD ENTRA EB, Руководство по установке

Страница: 2 / 80

2
ENTRA EB
Thank you for choosing this product. For best automatism performance, we recommend you carefully read
and follow the installation and use instructions found in this manual. Installation of this automatism must
only be performed by the professionally qualified personnel for whom this manual is addressed. Any errors
during installation may be harmful to people or things. Packaging material (wood, plastic, cardboard, etc.)
should not be scattered in the environment or left within the reach of children as potential sources of danger.
Every installation phase must be performed in accordance with the regulations in force and following Good
Technique standards. Before beginning installation make sure that the product is integral and has not been
damaged during transportation or by poor storage conditions. Before installing the product make sure that
each architectural and structural element of the entrance (girder fastening surfaces, casings, guide, etc.) is
appropriate and sufficiently robust to be automated. Conduct a careful risk analysis and make suitable
modifications to eliminate conveyance, crushing, cutting and hazardous areas in general. Do not install the
product in environments where gas, steam or inflammable fumes are present. The manufacturer is not liable
for any neglect of “good technique” or specific regulations in the construc tion of the casing to be motorized
and any collapse of the same. All automatic entrance safety and protection devices (photocells, active
sensors, etc.) must be installed in accordance with the regulations and directives in force, with the completed
risk analysis, system type, use, traffic, forces and inertia in play. Pay careful attention to area where the
following may occur: crushing, cutting, conveyance and any other type of hazard in general applying, if
necessary suitable indications. Indicate the motorized door identification information on every installation.
Make sure that the upstream electrical system is correctly dimensioned and has all the opportune protections
(circuit breakers and fuses). Only use original spare parts in maintenance and repairs. Do not tamper or alter
devices in the automatism and all the safety devices in the control panel for any reason. The manufacturer is
not liable if parts within the automatism are altered or tampered with or if safety devices other than those
indicated by the manufacturer are used in the system. The automatism installer must provide the automatic
entrance manager with the use manual and all the information required for correct use in automatic and
manual modes (even for electronic locking) and in the event of emergency. Pay careful attention to the
messages in this manual that are marked with the hazard symbol. They can either be warnings aimed at
avoided potential equipment damage or specific signals of potential hazard to the installer and others. This
device was designed to automate pedestrian swinging doors. Any other use is considered contrary to the
use foreseen by the manufacturer who therefore shall not be held liable.
Before carrying out any operation it is necessary to read this manual carefully and follow all the
instructions, with particular attention to those indicated by the following references:
DANGER:
indications that, if not followed scrupulously, could generate sources of
danger or death
ATTENTION:
indications that, if not followed scrupulously, could generate
malfunctions