Gateway ALR 9000, Поддержание и устранение неисправностей

Страница: 61 / 66

Troubleshooting 47
Installation Problems
Problem Probable Cause Solution(s)
A drive is not
recognized by the
system. The BIOS Setup program reflects
the wrong parameters. Enter the BIOS Setup program and enter
the appropriate parameters for the device.
The device is not formatted. Format the drive.
The device controller is not
configured properly. Check jumpers and cable connections.
Memory errors were
detected during the
power-up sequence. Memory was added or removed
and the new configuration was not
saved in BIOS Setup. Enter BIOS Setup and save the new
memory configuration.
A memory DIMM was installed
incorrectly. Check the DIMMs for proper installation.
A memory DIMM is not
functioning properly. Replace the faulty DIMM.
An adapter card is not
recognized by the
system. The interrupt and/or I/O address is
set incorrectly. Check the address configuration of the
adapter card and ensure it does not
conflict with another card in the system.
The Power LED is
flashing. ECC memory failure has occurred. Press the Keyboard Inhibit Switch IN and
then OUT.
NOTE: If the Keyboard Inhibit Switch is
already in locked position (IN), you must
first unlock it (OUT) and then lock it back
(IN) to reset the ECC memory status and
the Power LED.
The Power LED
continues to flash
after ECC reset. A DIMM was incorrectly installed. Check the DIMM for proper installation
A DIMM is not functioning
properly. Replace the faulty DIMM.
Maints.boo Page 47 Friday, July 10, 1998 1:47 PM