78
79
wish to use the timer also, you do not need to make any further settings. Start
the appliance via the on/off button. When the timer shall be used, proceed with
the next section (see: ‘Setting the Internal Clock’).
NOTE
When using the grinder, the Coffee Machine Grind & Brew Pro offers 3 para-
meters, that can be combined freely for getting your desired results. For your first
steps, you should select a medium grind size.
• The grind size (from coarse to fine) has an influence on the water flow through
the coffee powder and the extraction of flavours. Turn the adjusting dial of the
grinder to the left (small icons) to select a finer grind size, or turn it to the right
(large icons) for getting the coffee powder somewhat coarser.
• In any case, you should adapt the number of cups set at the control panel accor-
ding to the amount of water in the water tank (2, 4, 6, 8, 10, or 12 cups). For
this, use the cups button. For your first tries, you should select the amount of water
in the water tank.
• Additionally, via the strength button, you can also select the amount of coffee
power that will be given off into the filter. The currently selected strength is repre-
sented by the assigned bean icons on the display area: contour (weak), dotted
(medium), or filled (strong).
These parameters can be combined freely according to your requirements.
9. Touch the cups button to select the number of cups shown on the left side of the
display below the time.
NOTE
There is no restriction to set this value according to the amount of water in the water
tank. You can select any other number of cups to your individual liking. Depen-
ding on this setting, the brewed coffee will get stronger or weaker (see: ‘Tips for
Best Results’).
10. Touch the strength button until the desired strength icon is shown below the time
display.
11. The grind size is selected at the adjusting dial on top of the brewing head. Turn
the dot on the adjusting dial to the desired icon: weak (small icons) to strong
(large icons).
SETTING THE INTERNAL CLOCK
In the centre of the display area, the current time of the internal clock is shown. The
clock is operating in 24 hours mode.
NOTE
With manual operation, it is not essential to set the clock. However, if you wish
to use the timer, you must set the clock first. Otherwise, the starting time cannot be
determined correctly.
IMPORTANT -
After any interruption of the power supply, the internal clock of
the appliance starts at 12:00 (high noon), when the appliance is connected to
the power supply again. However, as long as the appliance is connected to the
power supply, the clock will run on even after the automatic shut-off switches off
the operating panel (see: ‘Memory Function’ and ‘Keep Warm Function and Auto-
matic Shut-Off’).
12. For setting the internal clock simply touch the hour button and/or minutes button
until the correct time is shown. The displayed time flashes during setting. If you
do not touch the appropriate buttons again, the time will be displayed continu-
ously after approx. 2 seconds.
NOTE
When leaving your finger on the hours button or minutes button, the display runs
on automatically until you remove your finger.
USING THE TIMER
Via the timer, the brewing cycle can be started at a pre-selected starting time. Using
this feature, your Coffee Machine Grind & Brew Pro can wait for you with freshly
brewed coffee, whenever you like.
WARNING
–
When using the timer, the coffee maker starts operation auto-
matically at the pre-selected point in time without any supervision. Always ensu-
re that you have prepared the appliance for operation completely and correctly
according to the instructions given above, before activating timer operation!
Otherwise, hot water and hot coffee could run out and cause severe damage.
IMPORTANT -
Before setting the starting time and activating the timer, you need
to set the internal clock of the appliance (see above: ‘Setting the Internal Clock’).
