Gaspardo GENIUS, Инструкции по использованию и сборке / Запасные части, Страница: 12 / 37

USE AND MAINTENANCE
ENGLISH
g
cod. G19502880
38
3.5.1 COMPLETION OF THE MACHINE - (CENTAURO / PA1 SEED)
INSTALLING THE PASS SENSOR “FINGER”
Place the machine on the ground in work position (Fig. 8) before
installing the switch (S).
Set the stop piece (U) against the lever (V) at a measure equal to
the cylinder rod diameter plus 5mm (approx.).
IMPORTANT! The switch rod (S in Fig. 9) must be subjected to
stresses exclusively when the equipment is lifted with the
supplied lever (T in Figs. 9 and 10) at headland.
After installation, lift the equipment and check that the switch rod
(S) is subjected to stress (Fig. 10).
J
K
L
J
fig. 10
fig. 8
fig. 9
S
S
U
V
T
fig. 11
T
R
S
fig. 12 fig. 14 fig. 13
Q
INSTALLING THE CARDAN SHAFT ROTATION SENSOR
Before installing this sensor (L in Fig. 11), disengage the PTO,
place the equipment on the ground sitting on the supplied
supports, turn the tractor off, make sure it cannot move and
remove the ignition key.
WARNING: comply with the reading distance between the
sensor and the cardan shaft indicated in the figure. Do not
excessively tighten the two bolts holding the sensor in place.
3.6 ELECTRICAL CONNECTION
First, hook up the rear and front equipment to the tractor following the instructions provided in the corresponding manuals. Then,
connect to the electrical system (refer to the drawings on pages 8, 9, 10 and 11).
Connection to the electrical box of
tramlining motors (only for seed
versions). Connection to the main electrical panel. Connection of power cable to battery.