CMM USER'S MANUAL (E2.51)
35
4.2.3 HW status
The
HW Status
button opens a dialog that displays the current values, target values & status of the
most important parameters of both the analyzer and test gas generator. The following table shows list
of important parameters. Status indicates if there is any corresponding alarm active for that parameter.
In case of alarm “NOK” is displayed and “OK” when no alarm.
Target
Status
Analyzer
Lamp temperature (
°C
)
Oven temperature (
°C
)
Cell temperature (
°C
)
Line temperature (
°C
)
Cell pressure (mbar)
Ambient pressure (mbar)
Detector counts
Test gas generator
Bath temperature (
°C
)
Evaporator temperature (
°C
)
Bath flow (ml/min)
Dilution flow (l/min)
Pump flow (µg/min)
Bath pressure (mbar)
Last Adjustments
Hg0 span (µg/m³)
Zero (µg/m³)
Table 9. ‘HW Status’ dialog parameters
The
Update
button sets the dialog in a continuous update mode where parameters are updated every
second except
‘Detector counts’
and
‘Last Adjustments”
values.
Detector counts
are updated after
every measurement and
‘Last adjustments’
values are updated after Zero/Hg
0
span adjustment.
Figure 22. ‘HW Status’ dialog
