Garmin GDL 82, Руководство по установке

Страница: 67 / 68

Interconnect Drawings
190-01810-00 GDL 82 TSO Installation Manual
Rev. 5 Page 10-3
NOTES
Figure 10-1 Typical Installation
Sheet 2 of 2
CIRCUIT BREAKER MUST BE LABELED AS SHOWN AND READILY ACCESSIBLE TO THE PILOT. THE
LABEL MUST BE DIRECTLY ADJACENT TO THE CIRCUIT BREAKER.
THE GDL 82 CAN BE PROTECTED BY THE EXISTING TRANSPONDER CIRCUIT BREAKER. THE
COMBINED TRANSPONDER AND GDL 82 CURRENT MUST NOT EXCEED 80% OF THE CIRCUIT
BREAKER RATED CURRENT. REPLACE EXISTING CIRCUIT BREAKER IN ACCORDANCE WITH AC
43.13-1B, CHAPTER 11, SECTION 4, IF REQUIRED.
USB TYPE B RECEPTACLE PIGTAIL (P/N 011-01782-00) MUST BE WIRED DIRECTLY TO P821 TO
MINIMIZE LIGHTNING EXPOSURE. LABEL AND PLACE IN ACCESSIBLE LOCATION.
A GROUND WIRE BETWEEN THE GDL 82 AND THE GNS 400W/500W SERIES GPS SOURCE IS NOT
NEEDED.
IF THE SPECIFIED RS-232 PORT ON THE GTN 6XX/7XX OR GNS 400W/500W SERIES NAVIGATORS
IS ALREADY USED, ANY RS-232 PORT MAY BE CONNECTED.
FOR THE GNS 480 (CNX80), THE RS-232 SERIAL PORT, CHANNEL 3, IS THE ONLY PORT THAT
ALLOWS FOR THE ADS-B OUT+ FORMAT TO INTERFACE AS AN EXTERNAL GPS SOURCE TO THE
GDL 82.
REFER TO SECTION 6.2 FOR L-BAND AND GPS ANTENNA COAXIAL CABLE SPECIFICATIONS.
EXTERNAL GPS SOURCE IS ONLY REQUIRED FOR GDL 82 UNITS NOT EQUIPPED WITH INTERNAL
GPS AND/OR INTERFACED TO GPS ANTENNA.
OPTIONAL INSTALLATION: THESE INPUTS MUST BE CONFIGURED IF INSTALLED. REFER TO
SECTION 7 FOR CONFIGURATION SETTINGS.
THE SQUAT SWITCH INPUT CAN BE USED TO CONTROL AIR/GROUND STATUS. AN AIRSPEED
GEAR SAFE SWITCH COULD BE USED INSTEAD OF A WEIGHT ON WHEELS OR SQUAT SWITCH IF
PRESENT.
THE ANONYMOUS MODE SWITCH MAY BE USED TO CONTROL THE GDL 82 ANONYMITY
FEATURE. THE SWITCH MUST BE LABELED AS SHOWN DIRECTLY ADJACENT TO THE SWITCH.
1
2
3
4
5
6
7
8
9
10
11