7
cHaPter 1: Basic setuP
install tHe deVice
standard mount
1.
select a secure location to mount the eDGe
®
where it does not
interfere with the safe operation of your bike.
2.
Place the rubber disk
1
on the back of the bike mount. the
rubber tabs align with the back of the bike mount so it stays in
place.
3.
Place the bike mount on the bike stem.
4.
attach the bike mount securely using the two bands
2
.
5.
align the tabs on the back of the eDGe
®
with the bike mount
notches
3
.
6.
Press down slightly and turn the eDGe
®
clockwise until it locks
into place.
out-front mount
1.
select a secure location to mount the eDGe
®
device where it
does not inter fere with the safe operation of your bike.
2.
use the hex key to remove the screw
1
from the handlebar
connector
2
.
3.
if necessary, remove the two screws on the back side of the
mount
3
, rotate the connector
4
, and replace the screws to
change the orientation of the mount.
4.
Place the rubber pad around the handlebar:
– if the handlebar diameter is 25.4 mm, use the thicker pad.
– if the handlebar diameter is 31.8 mm, use the thinner pad.
5.
Place the handlebar connector around the rubber pad.
6.
replace and tighten the screw.
7.
align the tabs on the back of the eDGe
®
device with the bike
mount notches
5
.
8.
Press down slightly and turn the eDGe
®
device clockwise until it
locks into place.
releasing the edGe
1.
turn the eDGe
®
clockwise to unlock the device.
2.
lift the eDGe
®
off the mount.
TIP:
For the best GPS reception, position the bike mount so the front of the EDGE
®
is oriented
toward the sky. You can install the bike mount on the stem or the handlebars.
NOTE:
Garmin
®
recommends a torque
specification of 7 lbf-in.
(0.8 N-m). You should
check the tightness of the
screw periodically.
150217_Garmin_Quickguide_BIKE_GPS_Devices_RZ.indd 7
17.02.15 16:54
