51
for vector s system: installing the left Pedal and
Pedal Pod
1.
apply a thin layer of grease on the pedal spindle
1
and the
pedal pod
2
where it contacts the pedal spindle.
2.
on the pedal spindle, stack the pedal pod and any required
washers
3
.
3.
insert the spindle into the crank arm
5
.
4.
Hand tighten the spindle.
5.
rotate the crank arm to check for clearance. the pedal pod
should not interfere with any part of the bike.
6.
use the pedal wrench to tighten the spindle.
7.
firmly plug the cable into the spindle.
8.
rotate the crank arm to check for clearance.
for vector s system: installing the right Pedal
this procedure is for the vector s system.
1.
apply a thin layer of grease on the pedal spindle.
2.
insert the spindle into the crank arm.
3.
Hand tighten the spindle.
4.
use the pedal wrench to tighten the spindle.
NOTE
The left pedal spindle has a left-handed (reverse) thread.
NOTE
Garmin recommends torque of 25 to 30 lbf-ft. (34 to 40 N-m).
NOTE
Garmin recommends torque of 25 to 30 lbf-ft. (34 to 40 N-m).
TIP
You must carefully bend the cable
4
out of the way.
TIP
Power and cadence
calculations are not
impacted by the orientation
of the pedal pod. Garmin
®
recommends placement
of the pedal pod on the
leading edge of the crank.
When the crank is in the
forward position, the pedal
pod should be pointing
downward.
cHaPter 7: vector
NOTE
Do not use more than two
washers.
NOTE
If you used one or two
washers on the left pedal,
use the same amount on
the right pedal.
150217_Garmin_Quickguide_BIKE_GPS_Devices_RZ.indd 51
17.02.15 16:55