![background image](http://html1.mh-extra.com/html/garland/montana-first/montana-first_instruction-manual_3600255045.webp)
English
44/172
English
45/172
If the brake is operating correctly, the chain should
not move when it comes into contact with the wood. If
the brake does not work correctly take the tool to the
customer service.
Do not start the chainsaw with the safety brake
activated. If the motor is running and the chain is
blocked by the brake, the clutch will overheat and this
could cause damage. If the brake is activated with
the tool running, remove your fingers from the throttle
trigger and leave the tool idling. Check why the safety
brake has been activated later.
6.3.2. FUEL AND OIL MIX
IMPORTANT: The engine fuel is highly
inflammable. If the fuel or tool catch fire,
please extinguish it using a dry powder fire
extinguisher.
Always avoid contact of gasoline or oil in your eyes. If
gas or oil in contact with eyes rinse immediately with
clean water. If your eyes feel irritated then immediately
consult a doctor.
Use new lead free 95º petrol and synthetic oil for two
stroke engines.
Engine fuel: mix (petrol 40: oil 1) 2,5%.
Do not smoke when filling the fuel tank. Do
not smoke and keep the fuel away from a
naked flames or sparks.
Do not remove the fuel tank cap while the
engine is running.
Never add fuel while the engine is running
or still hot. If petrol is spilt during the filling
process, make sure it is completely eliminated by
using cloths to absorb it.
Do not add fuel near a naked flame or in a
closed or badly ventilated area.
Always keep the fuel in a properly labeled container
whose use has been approved by the local codes and
regulations.
Mix gasoline and oil in a container approved CE.
Do not use fuel which has been stored for more than
two months. Fuel which has been stored for a long
time makes it difficult to start the engine and it will
produce an unsatisfactory performance from the
engine. If the fuel has been stored for more than two
months, it must be substituted for new fuel.
Filling the tank with fuel:
1. Fill the tank in an open area.
2. Shake the container which holds the mix.
3. Remove the lid from the tank and pour the mix
inside.
4. Close the lid of the tank firmly and remove any spilt
fuel with a cloth.
WARNING:
Always stop the engine before adding fuel
to the tool.
Do not carry out this operation in a badly
ventilated closed area.
Before starting the engine, move at least 3 meters
away from the place where the fuel was added.
Содержание MONTANA FIRST
