Garland EDU-15HSE, Инструкция по установке и эксплуатации

Страница: 8 / 24

Part # 4521353 (06/17/09) Page 8
FRONT VIEW
1. Level each unit by adjustment of leveling bolts or legs.
Use a spirit level and level unit four ways; across front and
back and down left and right edges. Level all other units
to the first unit.
NOTE: Griddles may not rest evenly on the unit body if units
are not leveled.
2. Remove acorn nuts at rear of unit.
3. Attach one banking plate in position at rear by placing
1/4” (6.4 mm) diameter holes in the banking plate over the
screw holes in the rear of units and fasten by replacing the
acorn nuts removed in step 2.
4. Push units into position on counter top or back bar.
5. To secure the front, open the lower front panel, place
banking plate over the two holes (one on each unit) and
secure banking plate using sheet metal screws supplied.
Sanitary Counter Top Seal
When appliance is installed without legs on a counter top, it
must be sealed in accordance with N.S.F. standards as per the
following instructions:
1. Appliance should be located on a level counter top
surface. Complete the electrical connection.
2. Thoroughly clean the appliance bottom perimeter and
the counter top area around the appliance perimeter.
GENERAL INSTALLATION continued
3. Lay a generous bead of silicone under the entire
perimeter of appliance bottom.
4. Secure unit to counter top through the holes located on
the underside of the appliance using 10A sheet metal
screws.
5. Smooth the silicone seal into the crevice with finger or
tool to provide a cove seal.
COUNTER TOP
SILICONE SEALANT
Leg Installation
The leg channel is located onthe package base. This channel
must be installed when using the legs.
BOTTOM OF UNIT
LEG CHANNEL
(QTY 2)
4" [102mm]
ADJUSTABLE LEG
(QTY 4)
LEG INSTALLATION