Garland EDU-15HSE, Инструкция по установке и эксплуатации, Страница: 9 / 24

Part # 4521353 (06/17/09) Page 9
Installation Of Counter Stands (Optional)
1. Assemble and level counter stand as illustrated in the
instructions found in the counter stand carton.
2. Remove and discard leveling bolts on unit to be installed
on counter stand.
3. Place units in desired position on counter stand, securing
the first unit with 8-32 machine screws and flat washers.
Insert 8-32 machine screws through the 7/32” (5mm)
diameter holes in stand into the nutserts in the bottom of
EDU Series unit.
GENERAL INSTALLATION continued
4. Connect banking plates as described in section titled,
Installation of Banking Plates.
5. Secure last unit to counter stand with 8-32 machine screws
and flat washers. Inserts 8-32 machine screws through
the 7/32” (5mm) diameter holes in stand into the nutserts
in the bottom of EDU series unit.
INDIVIDUAL MODEL INSTALLATIONS
Solid Element Hot Plate;
Model EDU-15HSE
Wall Clearances
Do not install the appliance closer to a wall of combustible
material than :
Back: 1-1/2” (38mm)
Sides 1-1/2” (38mm)
Electrical Supply
Before attempting the electrical connection, the rating noted
on the serial plate should be checked, to ensure that the
appliance electrical characteristics and the supply electrical
characteristics agree. The electrical supply must be adequate
for the voltage, phase and current marked on the serial plate.
Use only wires suitable for 75°C (167°F).
The supply cable entrance is located on the right side, when
facing the rear of the unit. The cable is fed towards the front
through a wire way.
A knockout is provided near the front left side of the unit,
located behind the control panel. To access the knockout,
loosen the two acorn nuts and hinge the control panel
downwards. The terminal block is also located in this area.
Controls
Solid element hot plates are controlled by six heat switches.
There are three boiling and three simmering positions. Turn
the switch left or right from the off position to the desired
number, one being the lowest setting and six being the
highest.
Switch
Position Wattage
Heat
1 240
Low
(Simmer)
2 340
3 450 Medium
4 1300
High (Boil) 5 1750
6 2600
This hot plate is protected against overheating when
running empty or when using poor quality cookware, by a
unique built-in bimetal protector switch. The protector cuts
down the power automatically under the above conditions
before overriding the regulator switch and returning itself to
normal, this is an important feature.