Garland EDU-15HSE, Инструкция по установке и эксплуатации

Страница: 18 / 24

Part # 4521353 (06/17/09) Page 18
5. Remove the wire grounding the element clamp to the
body and remove the nuts that secure the element
clamp/baffle to the bottom of the griddle plate. Lower
the clamp/baffle and remove the faulty element.
6. Reassemble the replacement element, secure properly
with the clamp/baffle.
7. Reassemble in reverse order.
Broilers
Elements:
To replace a faulty element, first turn off all electrical mains.
1. Raise the relevant casting sufficient to remove the tilting
stop rod toward the rear.
2. Lift out the casting and element assembly. Remove the
clamps that secure the faulty element to the casting,
remove the four screws that secure the element to the
termination box and remove the faulty element.
3. Install the replacement element,
4. Reassemble in the reverse order.
Infinite Switch (Energy Regulator):
To replace a faulty infinite switch, first turn off the electrical
mains.
1. Loosen the two acorn nuts that secure the control panel
and hinge the control panel downward.
2. Remove the dial of the faulty switch and remove the
two screws that secure the switch to the control panel.
Leave the wires attached to the faulty switch, until the
replacement switch has been mounted on the control
panel.
3. Remove one wire at a time from the faulty switch and
immediately connect it to the same terminal on the new
switch.
4. Reassemble in the reverse order.
Indicator Lamp:
If it is necessary to change the indicator lamp, first turn off
the electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the panel downwards.
SERVICING continued
2. Disconnect the supply wires to the lamp body and
remove the faulty lamp.
3. Install the replacement lamp in the control panel.
4. Reassemble in the reverse order.
Food Warmers
Elements:
If it is necessary to replace a faulty element, first turn off the
electrical mains.
1. Lift out the tank. Remove the screws (4) that secure
the baffle above the element and lift up the element.
Disconnect the wires from the element terminals and
take out the faulty element.
2. Reconnect the wires to the terminals of the replacement
element.
3. Reassemble in the reverse order.
Infinite Switch:
If it is necessary to replace a faulty switch, first turn off all
electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the panel downward.
2. Remove the dial from the faulty switch and remove the
two screws that secure the switch to the control panel.
Leave the wires attached to the faulty switch until the
replacement has been mounted on the control panel.
3. Remove one wire at a time from the faulty switch and
immediately connect it to the same terminal on the new
switch.
4. Reassemble in the reverse order.
Indicator Lamp:
If it is necessary to change the indicator lamp, first turn off
the electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the panel downwards.
2. Disconnect the supply wires to the lamp body and
remove the faulty lamp.
3. Install the replacement lamp in the control panel.
4. Reassemble in the reverse order.