Garland EDU-15HSE, Инструкция по установке и эксплуатации

Страница: 17 / 24

Part # 4521353 (06/17/09) Page 17
3. Reach in though the access opening with a 10mm
wrench and remove the nuts that secure the wire-way,
at the center of each element and drop the wire-way.
Remove the second nut that at the center of the element,
remove the ground wires and drop the second screening
sheet. Lift out the faulty element.
4. Remove one wire at a time for the faulty element and
immediately connect it to the same terminal on the
replacement element. Discard faulty element.
5. Install the replacement element in the hot plate top with
the element terminations in the original position. Secure
with the screening sheet, ground wire and nut.
6. Reassemble in the reverse order.
Six Heat Switch
If it is necessary to change faulty switch, first turn off
electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the control panel downwards.
2. Remove the dial from the faulty switch and remove the
two screws that secure the switch to the control panel.
Leave the wires attached to the faulty switch, until the
replacement switch has been mounted on the control
panel.
3. Remove one wire at a time from the faulty switch and
immediately connect it to the same terminal on the new
switch.
4. Reassemble in the reverse order.
Indicator Lamp:
If it is necessary to change the indicator lamp, first turn off
the electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the panel downwards.
2. Disconnect the supply wires to the lamp body and
remove the faulty lamp.
3. Install the replacement lamp in the control panel.
4. Reassemble in reverse order.
Griddles
Follow the instructions in Griddle installation, calibration to
check thermostat calibration.
SERVICING continued
Thermostat:
If it is necessary to replace a thermostat, first turn off the
electrical main.
1. Loosen the two acorn nuts securing the control panel
and hinge the control panel downward.
2. Remove the clip/s that secures the griddle to the body, at
the front.
3. Raise the griddle and engage the support prop in the
hole in the switch guard.
4. Loosen the two nuts that secure the clamp over the
sensing bulb and withdraw this bulb.
5. Remove the two screws that secure the thermostat to the
control panel, after first removing the control dial.
6. Disconnect the wires from the taps on the thermostat. Be
sure to note which terminal on the thermostat.
7. Remove the faulty thermostat and re-assemble the
replacement thermostat in the reverse order.
Indicator Lamp:
If it is necessary to replace an indicator lamp, first turn off the
electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the panel downward.
2. Disconnect the supply wires to the lamp body and
remove the faulty lamp.
3. Install the replacement lamp in the control panel.
4. Reassemble in the reverse order.
Element:
If it is necessary to replace a griddle element, first turn off all
the electrical mains.
1. Loosen the two acorn nuts securing the control panel
and hinge the control panel downward.
2. Remove the clip/s that secure the griddle to the body, at
the front.
3. Raise the griddle and engage the support prop in the
hole in the switch guard.
4. Disconnect the wires from the element terminal.