Gardsman CTC-1052, Руководство пользователя

Страница: 21 / 46

18
Command 76
Call Progress Tone

This command is used to turn on/off the
dialing tone of phone calls while making
alarm reporting.
Function Selection Result
(0)
OFF
(Disable)
(1) ON
<NOTE>

When this function is set to ON , you will
hear a dialing tone from the speaker
indicating the status of phone calls.

When this function is set to OFF , you
will not hear the dialing tone of phone
calls.

This function will be disabled if
Command 35 is set as Enable .

This function will be disabled if alarm
activation is made from a
Silent
Device (learnt using Command #93).

Factory default is ( 0 ), OFF .
Command 77
Speech Report ACK

A two-way communication is established
when a call is made from CTC-1052 to the
Monitoring Center by sending out a speech
report.

When speech report is set to ( 0 ), press any
DTMF key for panel to regard speech reporting
successful
.

When speech reporting is set to ( 1 ), off-hook
phone for panel to regard speech reporting
successful.

Factory default is ( 0 ), Any DTMF.
Function Selection Result
(0) Any DTMF
(1) OFF-HOOK
Command 78
Mobility Time Out Warning

When Mobility Time expires and no reset
signal is received, CTC-1052 will emit a long
beep every 5 minutes in 30 minutes. This
warning can be enabled or disabled.

Factory default is ( 1 ), Enable.
Function Selection Result
(0) Disable
(1) Enable
Command 80
Remove Devices
 CTC-1052 can be programmed to remove
ALL
previously learnt devices by entering
( 80) followed by (
＃
).
After entering command ( 80 ) (
＃
), the
system will immediately emit an
acknowledging beep over the phone.
Continue to hold the phone set until you
hear the second acknowledging beep after
12 seconds.
Command 93
Learn-In Silent Pendant
<NOTE>

This command is not available in
Remote Programming Mode.

Only one Silent Pendant can be learnt into
CTC-1052 by using Command #93.

For learning Silent Pendant :
Step 1: Enter 93 + # on the phone set, then
a short beep will be heard via the
phone set. (If no command is dialed,
CTC-1052 will exit Programming
mode automatically and return to
idle mode).
Step 2: Press the Pendant Button within 20
seconds.

Learning can only be completed
within the signal reception range of
CTC-1052.