Gardsman CTC-1052, Руководство пользователя

Страница: 15 / 46

12
within 15 seconds. Otherwise, CTC-
1052
will disconnect the call
automatically.

To terminate the call, press DTMF ( 9 ),
( 0 ) or Green Reset Button on CTC-
1052.

If the 5-minute waiting period is up,
CTC-1052 will automatically exit this
waiting mode and return to idle mode.
Command 40
Set Access Code

The Access Code is used to enter
Programming Menu (locally or remotely),
and the Call-Back Function.

It consists of 4 digits and has been set to
( 1111 ) as factory default. Before you set
your own Access Code, ( 1111 ) must be
keyed in.

To set a new Access code; enter the
desired (
4-digit number) in Function
Selection .
Command 41
Auto Answer for Remote Programming

CTC-1052 can be programmed to auto
answer incoming phone calls after a pre-set
number of rings have been reached. The
number of rings range from (
00 ) (no auto
answer) to ( 32 ) rings.
Function Selection Result
(00) OFF
(01) - (32) ON

Factory Default is ( 00 ) Rings.
<NOTE>

When ( 00) , it means CTC-1052 cannot
auto-answer the call by ring count. If
you want to do Remote programming,
please follow the Remote Programming
method described in
3. System
Confguration, 3.1. Entering
Programming Mode, 3.1.3 Remote
Programming Mode.
Command 42
Guard Time Delay
This command is designed for any
compatible sensor, except Fall Sensor
(fall detection).

Guard Time Delay time is a time period
programmed to delay alarm reporting. If a
false alarm is raised, it can be cancelled
within this Guard Time Delay time.

The programmable delay time range from
(
00 ) (instant reporting) to ( 99 ) seconds.

Emergency alarms activated by Smoke
Detectors
(SD), Carbon Monoxide
Detectors (CO), and Water Sensors (WS)
do not have Guard Time Delay and will be
reported immediately.
Function Selection Result
(00) INSTANT REPORTING
(01) - (99) DELAY

Factory Default is ( 10 ), 10 SECONDS .

Alarm activated by pressing a button
cannot be cancelled after the Guard Time is
elapsed.
<NOTE>

The Guard Time Delay time from
pressing the Active Button on a Fall
sensor is determined by Command #42
instead of Command #66.

The Guard Time Delay from a fall
detection (of a Fall Sensor) is set by
Command #66 .